Brother International SE2000 Operation Manual - Page 105
Appendix
View all Brother International SE2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 105 highlights
5 Chapter APPENDIX Care and Maintenance Care and Maintenance CAUTION • Unplug the power cord before cleaning the machine, otherwise injuries may occur. Cleaning the LCD If the surface of the LCD is dirty, lightly wipe it with a soft dry cloth. Cleaning the machine surface When wiping dirt off the machine, firmly wring a soft cloth soaked in (lukewarm) water. After cleaning the machine, dry it with a soft, dry cloth. Restrictions on oiling In order to prevent damaging this machine, it must not be oiled by the user. This machine was manufactured with the necessary amount of oil applied to ensure correct operation, making periodic oiling unnecessary. If problems occur, such as difficulty turning the handwheel or an unusual noise, immediately stop using the machine, and contact your authorized Brother dealer or the nearest Brother authorized service center. Cleaning the race Stitching performance will suffer if lint and dust collects in the bobbin case, therefore, it should be cleaned regularly. Press (Needle position button) to raise the needle. a Turn off the machine. b Unplug the power cord from the power supply jack on c the right side of the machine. Raise the presser foot to remove the needle and presser d foot. • For details, refer to "Replacing the Needle" on page 29 and "Replacing the Presser Foot" on page 30. Remove the flat bed attachment or the embroidery unit e if either is attached. Remove the bobbin cover. f 5 Remove the needle plate cover. g APPENDIX ■ If there is a screw in the needle plate cover 1 Use the disc-shaped screwdriver to remove the screw in the needle plate cover. Precautions on storing the machine Do not store the machine in any of the locations described below, otherwise damage to the machine may result, for example, rust caused by condensation. • Exposed to extremely high temperatures • Exposed to extremely low temperatures • Exposed to extreme temperature changes • Exposed to high humidity or steam • Near a flame, heater or air conditioner • Outdoors or exposed to direct sunlight • Exposed to extremely dusty or oily environments Note • In order to extend the life of this machine, periodically turn it on and use it. Storing this machine for an extended period of time without using it may reduce its efficiency. 2 Grasp both sides of the needle plate cover, and then slide it toward you. ■ If there is no screw in the needle plate cover 1 Grasp both sides of the needle plate cover, and then slide it toward you. 103