Brother International SE2000 Operation Manual - Page 26
Winding/Installing the Bobbin
View all Brother International SE2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
Winding/Installing the Bobbin Slide the bobbin cover latch to the right and remove e the bobbin cover. While lightly holding down the bobbin with your right h hand (1), guide the thread through the slit in the needle plate cover (2) and lightly pull it with your left hand (3). Insert the bobbin into the bobbin case so that the f thread unwinds to the left. Memo • For the correct winding direction of the bobbin thread, be sure to place the bobbin into the bobbin case in the same orientation that it was on the bobbin winder shaft. The "b" mark on one side of the bobbin included with this machine can be used as a reference. Memo • By pulling the thread in this way, the thread will enter the tension spring of the bobbin case to apply the appropriate tension to the bobbin thread during sewing. While lightly holding down the bobbin with your right i hand (1), continue guiding the thread through the slit with your left hand (2). Then, cut the thread with the cutter (3). Reattach the bobbin cover. j Insert the tab of the bobbin cover into the notch of the needle plate cover, and then lightly press down on the right side. Lightly hold down the bobbin with your right hand g (1), and then guide the end of the thread around the tab of the needle plate cover with your left hand (2). 1 Tab Touch k to unlock all keys and buttons. Note • Be sure to hold down the bobbin with your finger and unwind the bobbin thread correctly, otherwise the thread may break or the thread tension will be incorrect. 24