Brother International SE2000 Operation Manual - Page 93
Adjusting the bobbin case with no color on, the screw, Using the automatic thread cutting function,
View all Brother International SE2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 93 highlights
Adjusting the bobbin case (with no color on the screw) The bobbin case (with no color on the screw) can be adjusted when bobbin tension changes are required to accommodate different bobbin threads. Refer to "Embroidering attractive finishes" on page 80. To adjust the bobbin tension for embroidery function, using the bobbin case (with no color on the screw), turn the slottedhead screw (-) with a screwdriver (small). 1 Do not turn the phillips screw (+). 2 Adjust with a screwdriver (small). Embroidering IMPORTANT • When adjusting the bobbin case, be sure to remove the bobbin from the bobbin case. • DO NOT adjust the position of the phillips (+) screw on the bobbin case as this may result in damage to the bobbin case, rendering it unusable. • If the slotted-head screw (-) is difficult to turn, do not use force. Turning the screw too much or providing force in either (rotational) direction may cause damage to the bobbin case. Should damage occur, the bobbin case may not maintain proper tension. ■ Correct tension Upper thread slightly appears on the wrong side of fabric. 1 Right side 2 Wrong side ■ Bobbin thread is too loose Bobbin thread appears slightly on the right side of fabric. 1 Right side 2 Wrong side Using the automatic thread cutting function (End Color Trim) The automatic thread cutting function will cut the thread at the end of embroidering each color. This function is initially turned on. To turn this function off, touch key and then . Touch . a 4 EMBROIDERY If this occurs, turn the slotted-head screw (-) clockwise, being careful not to over-tighten the screw, approximately 30-45 degrees to increase bobbin tension. Touch to turn off the automatic thread cutting b function. ■ Bobbin thread is too tight Upper thread on the right side of fabric seems to be lifting/ looping and bobbin thread is not seen on the wrong side of fabric. 1 Right side 2 Wrong side The key will display as • When one color thread is embroidered, the machine will stop without cutting the thread. Touch c to return to the original screen. If this occurs, turn the slotted-head screw (-) counterclockwise, being careful not to over-loosen the screw, approximately 30-45 degrees to decrease bobbin tension. 91