Brother International SE2000 Operation Manual - Page 25
Important, Caution
View all Brother International SE2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
Turn on the machine. i • The "Start/Stop" button lights up in orange. Press the "Start/Stop" button to start winding the j bobbin. When the foot controller is plugged in, press down on the foot controller. IMPORTANT • When winding transparent nylon thread on the bobbin, stop bobbin winding when the bobbin is 1/2 to 2/3 full. If the bobbin was fully wound with transparent nylon thread, it may not be wound neatly, or sewing performance may suffer. In addition, extreme pressure may be applied to the bobbin, it may not be possible to remove the bobbin from the bobbin winder shaft, or the bobbin may break. Winding/Installing the Bobbin Installing the bobbin Install the bobbin wound with thread. You can begin sewing immediately without pulling up the bobbin thread by simply inserting the bobbin in the bobbin case and guiding the thread through the slit in the needle plate cover. 1 GETTING READY Memo • If the threads will be pulled to create gathers or the thread at the beginning of sewing will be finished, for example, when free motion quilting, first pull up the bobbin thread. For details, refer to "Pulling up the bobbin thread" on page 27. CAUTION • Use a bobbin that has been correctly wound with thread, otherwise there is a risk of poor thread tension or injury due to the needle breaking. When the bobbin winding becomes slow, press the k "Start/Stop" button to stop the machine. When the foot controller is plugged in, remove your foot from the foot controller. IMPORTANT • When the bobbin winding becomes slow, stop the machine, otherwise the machine may be damaged. Cut the thread, slide the bobbin winder shaft to the left l until it snaps into place, and then remove the bobbin. • Before inserting or changing the bobbin, be sure that you have touched on the operation panel to lock all keys and buttons, otherwise injuries may occur if the "Start/ Stop" button or any other button is pressed and the machine starts. Turn on the machine. a Press (Needle position button) once or twice to b raise the needle. Touch . c The screen changes, and all keys and operation buttons are locked (except ). Slide the sewing speed controller to desired sewing m speed position. Remove the spool for the bobbin thread from the spool n pin. Raise the presser foot lever. d 23