Brother International SE2000 Operation Manual - Page 61
Zipper insertion
View all Brother International SE2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 61 highlights
Utility Stitches ■ Attaching a shank to a button To sew the button with a shank, attach the button with space between it and the fabric, and then wind the thread by hand. This attaches the button securely. Place the button into button fitting foot "M", and then a pull the shank lever toward you. 1 Shank lever Using a basting stitch, continue sewing to the edge of c the fabric. a b 1 Basting stitching 2 Wrong side of fabric 1 After sewing is finished, cut the upper thread with b plenty of excess, wind it around the thread between the button and the fabric, and then tie it to the upper thread at the beginning of the stitching. Tie together the ends of the bobbin thread at the end and at the beginning of the stitching at the wrong side of the fabric. Cut off any excess thread. c Zipper insertion ■ Inserting a centered zipper Stitching is sewn on both pieces of fabric butted against each other. 1 Right side of fabric 2 Stitching 3 End of zipper opening 2 1 3 Attach zigzag foot "J". a Sew straight stitches up to the zipper opening. b With the right sides of the fabric facing each other, sew reverse stitches after reaching the zipper opening. 1 Reverse stitches 2 End of zipper opening a b Press open the seam allowance from the wrong side of d the fabric. 1 Wrong side of fabric 1 3 VARIOUS STITCHES Align the seam with the center of the zipper, and then e baste the zipper in place to the seam allowance. 1 Wrong side of fabric 2 Basting stitching 2 3 Zipper 1 3 Remove about 5 cm (2 inches) from the end of the f basting on the outside. 2 4 3 1 1 Wrong side of fabric 2 Zipper basting 3 Outside basting 4 5 cm (2 inches) Attach the presser foot holder to the right pin of zipper g foot "I". I 1 1 Pin on the right side 2 Needle drop point 2 Select stitch. h No. 1-03 Stitch • For details, refer to "Stitch Chart" on page 45. 59