Brother International SE2000 Operation Manual - Page 84
Attaching the embroidery frame
View all Brother International SE2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 84 highlights
Embroidering Preparation Gently remove the fabric from the frame without e loosening the adjustment screw. Place the embroidery sheet on the inner frame. b Line the mark on the fabric up with the base line on the c embroidery sheet. Memo • This precautionary step will help reduce pattern distortion while embroidering. Press the inner frame in from the top of the fabric f again, lining up on the inner frame and on outer frame. • Press the inner frame into the outer frame. Before beginning to embroider, make sure that the top edges of the inner and outer frames are aligned. Tighten the adjustment screw while removing any slack g in the fabric by hand. The goal is to have a drum-like sound when the fabric is struck lightly. Place the inner frame with the fabric on the outer d frame and adjust the fabric if needed to align marks on fabric with the embroidery sheet. • For details, refer to page 81. Remove the embroidery sheet. e Memo • You can use the included screwdriver when you loosen or tighten the frame adjustment screw. ■ Using the embroidery sheet When you want to embroider the pattern in a particular place, use the embroidery sheet with the frame. With a chalk pencil, mark the area of the fabric you a want to embroider. Attaching the embroidery frame Note • Wind and insert the bobbin before attaching the embroidery frame making sure to use the recommended bobbin thread. Check that there is enough thread in the bobbin. Raise the presser foot lever to raise the presser foot. a While lightly holding the lever on the frame holder to b the left, align the two pins on the embroidery frame holder with the mounting brackets on the frame, and then press the frame into the embroidery frame holder until a click is heard. Hold the lever lightly to the left. a 1 Lever 82