Brother International SE2000 Operation Manual - Page 79

4 Chapter EMBROIDERY Embroidering Preparation Embroidering Preparation Follow the steps below to prepare the machine for embroidery. Step 9 Step 3 Step 1, 2 Step 4 Step 5 Step 6 Step 7, 8 Step Aim # Action 1 Presser foot attachment Attach embroidery foot "Q". 2 Checking the needle Use needle 75/11 for embroidery. 3 Embroidery unit Attach the embroidery unit. attachment 4 Bobbin thread setup For the bobbin thread, wind embroidery bobbin thread and set it in place. 5 Fabric preparation Attach a stabilizer material to the fabric, and hoop it in the embroidery frame. 6 Embroidery frame attachment Attach the embroidery frame to the embroidery unit. 7 Pattern selection Select an embroidery pattern. 8 Checking the layout Check and adjust the size and position of the embroidery. 9 Embroidery thread setup Set up embroidery thread according to the pattern. Page 77 29 78 21 80 82 84 87 88 Attaching the embroidery foot CAUTION • Be sure to use the embroidery foot when doing embroidery. Using another presser foot may cause the needle to strike the presser foot. The needle may break, possibly resulting in injury. Press a (Needle position button) to raise the needle. Touch . b  The screen changes, and all keys and operation buttons are locked (except ). Remove the presser foot and presser foot holder. c • For details, refer to "Replacing the Presser Foot" on page 30. 4 EMBROIDERY Hold the embroidery foot "Q" with your right hand, as d shown. Hold the embroidery foot with your index finger wrapped around the lever at the back of the foot. b a 1 Lever 2 Embroidery foot bar 77