Brother International SE2000 Operation Manual - Page 11
Getting Ready
View all Brother International SE2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 11 highlights
Names of Machine Parts 1 Chapter GETTING READY Note • Be sure to install the latest software. Refer to "Updating Your Machine's Software" on page 116. Names of Machine Parts ■ Main parts a bc d e f g h o i n j k m l 9 Operation panel (page 11) 0 Knee lifter mounting slot (page 44) A Knee lifter (page 44) B Operation buttons and sewing speed controller (page 10) C Flat bed attachment (page 11, page 40) D Thread cutter (page 26) E Needle threader lever (page 27) F Handwheel Turn the handwheel toward you (counterclockwise) to raise and lower the needle to sew one stitch. G Handle Carry the machine by its handle when transporting. H Presser foot lever Raise and lower the presser foot lever to raise and lower the presser foot. I Feed dog position switch Use when lowering the feed dogs for free motion quilting* or button fitting, and when raising the feed dogs. (page 58) When the feed dogs are lowered, return to their original raised position after sewing is finished. The feed dogs are raised when the machine starts sewing. * The presser foot for free motion quilting is sold separately with some models. J Main power switch (page 12) K Power supply jack (page 12) L Foot controller (page 34) M Air vent The air vent allows the air surrounding the motor to circulate. Do not cover the air vent while the machine is being used. N Foot controller jack (page 34) O USB port (for a USB flash drive) (page 73, page 100) GETTING READY 1 p y x q IMPORTANT • Do not insert anything other than a USB flash r drive into the USB port. Anything else may damage the machine. s w t u v 1 Top cover 2 Thread guide plate (page 22) 3 Thread guide cover 4 Bobbin winding thread guide and pretension disk (page 22) 5 Spool cap (page 21) 6 Spool pin (page 21) 7 Bobbin winder (page 21) 8 LCD (liquid crystal display) (page 14) 9