Brother International SE2000 Operation Manual - Page 32

Replacing the Presser Foot Replacing the Presser Foot CAUTION • Use the appropriate presser foot for the type of stitch that you wish to sew, otherwise the needle may hit the presser foot. The needle may break, possibly resulting in injury. For details on the presser foot that should be used with the selected stitch, refer to "Stitch Chart" on page 45. IMPORTANT • Use presser feet designed specifically for this machine. Note • When a stitch is selected, the icon for the presser foot that should be used appears in the screen. Check that the correct presser foot is attached before starting to sew. If the wrong presser foot is installed, attach the appropriate presser foot. (page 14) Press the black button at the back of the presser foot d holder in order to remove the presser foot. a 1 Black button 2 Presser foot holder b Place the appropriate presser foot below the presser e foot holder so that the presser foot pin is aligned with the notch in the holder. 1 Presser foot holder 1 2 Notch 3 Pin 4 Presser foot type 2 J4 3 Slowly lower the presser foot lever so that the presser f foot pin snaps into the notch in the presser foot holder. b a c d Replacing the presser foot Press (Needle position button) once or twice to a raise the needle. Touch . b  The screen changes, and all keys and operation buttons are locked (except ). 1 Presser foot lever 2 Presser foot holder 3 Notch 4 Pin  The presser foot is attached. Raise the presser foot lever to check that the presser g foot is securely attached. CAUTION • When replacing the presser foot, be sure that you have touched on the operation panel to lock all keys and buttons, otherwise injuries may occur if the "Start/Stop" button or any other button is pressed and the machine starts. Raise the presser foot lever. c Touch h to unlock all keys and buttons. 30