Brother International SE2000 Operation Manual - Page 81
Removing the embroidery unit
View all Brother International SE2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 81 highlights
Insert the embroidery unit connection into the d connection port until it snaps into place. Embroidering Preparation ■ Removing the embroidery unit Make sure that the machine is completely stopped and follow the instructions below. Remove the embroidery frame. a • For details on removing the embroidery frame, refer to "Removing the embroidery frame" on page 84. Touch , and then touch . b Note • Make sure that there is no gap between the embroidery unit and the machine, otherwise the embroidery pattern may not be embroidered correctly. IMPORTANT • Do not push on the carriage when attaching the embroidery unit to the machine, otherwise damage to the embroidery unit may result. • Do not touch the connector in the embroidery unit connection slot. The connector could be damaged, and it may cause malfunctions. • Do not lift up on the embroidery carriage, and do not forcefully move it. It may cause malfunctions. Turn on the machine. e A message appears in the screen. Note • If [Opening Screen] is set [ON] within the settings screen, touch screen for the following message to appear. Be sure that no objects or hands are near the f embroidery unit and touch . The embroidery carriage moves into a position where it can be stored. Turn off the machine. c IMPORTANT • Always turn off the machine before removing the embroidery unit. It may cause malfunctions if removed when the machine is turned on. Hold the release button on the bottom left of the d embroidery unit, and slowly pull the embroidery unit to the left. EMBROIDERY 4 The carriage moves to its initial position. The screen for selecting the embroidery pattern type is displayed. Memo • Utility stitches cannot be selected when the embroidery unit is attached. 79