Brother International SE2000 Operation Manual - Page 110
If the thread becomes tangled under the, bobbin winder seat
View all Brother International SE2000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 110 highlights
Troubleshooting ■ Checking machine operations If the needle plate has been removed, check machine operations to confirm that installation has been completed correctly. Turn on the machine. a The needle will automatically move left and right. Note • If an error occurs, the machine may be malfunctioning, so contact your authorized Brother dealer or the nearest Brother authorized service center. Select Straight stitch (Middle). b • Refer to "Stitch Chart" on page 45. Note • Do not yet install the presser foot and thread. Slowly turn the handwheel toward you c (counterclockwise), and look from all sides to check that the needle falls at the center of the opening in the needle plate. If the needle or feed dogs make contact the needle plate, the machine may be malfunctioning; therefore, contact your nearest Brother authorized service center. 1 Opening in the needle plate 2 Handwheel Turn off the machine, and then install the bobbin and d presser foot. Never use a scratched or damaged presser foot. Otherwise, the needle may break, or sewing performance may suffer. • Refer to "Installing the bobbin" on page 23 and "Replacing the presser foot" on page 30. Correctly thread the machine. e • For details on threading the machine, refer to "Upper Threading" on page 25. Perform trial sewing with cotton fabric. f Note • Incorrect sewing may be the result of incorrect upper threading or sewing thin fabrics. If there are poor results from the trial sewing, check the upper threading or the type of fabric being used. If the thread becomes tangled under the bobbin winder seat If the bobbin winding starts when the thread is not passed under the pretension disk of the bobbin winding thread guide correctly, the thread may become tangled under the bobbin winder seat. CAUTION • Do not remove the bobbin winder seat even if the thread becomes tangled under the bobbin winder seat. Otherwise, there is a risk of being injured by the cutter of the bobbin winder seat. Do not remove the screw on the bobbin winder guide post, otherwise the machine may be damaged; you cannot wind off the thread by removing the screw. 1 1 Screw of the bobbin winder guide post Stop the bobbin winding. a Cut the thread with scissors beside the bobbin winding b thread guide. Slide the bobbin winder shaft to the left, and then c remove the bobbin from the shaft and cut the thread leading to the bobbin in order to be able to completely remove the bobbin from shaft. Hold the thread end with your left hand, and wind off d the thread clockwise from under the bobbin winder seat with your right hand as shown below. 108