Canon MultiPASS F80 MultiPASS F80 Basic Guide - Page 90
LCD messages - ink cartridges
View all Canon MultiPASS F80 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 90 highlights
LCD messages Reference abbreviations SS = Setup Sheet CG = Comprehensive Guide Message (Error code) Cause Action Details Fax Model AUTO REDIAL The machine is waiting to redial Wait for the machine to automatically CG the other party's number redial the number. If you want to because the line was busy or the cancel automatic redialing, wait until recipient did not answer when the machine starts dialing the you tried to send a document. number, press [Stop/Reset] then [T]. Fax Model BUSY/NO SIGNAL (#018) The telephone number you dialed is busy. Try sending the document at a later time. The fax number dialed was incorrect. Check the fax number and dial again. The other party's fax machine is Contact the other party and have not working. them check their fax machine. The other party is not using a G3 Contact the other party and ask them machine. to send or receive the document using a G3 machine. The touch tone/rotary pulse setting on your machine is incorrect. Set your machine to the setting that p. 7-1 matches your telephone line. p. 8-2 The receiving fax machine did not answer within 55 seconds (after all automatic redialing attempts). Contact the other party and have CG them check their fax machine. You can try to send the document using manual sending. For an overseas call, add pauses to the registered number. C INK EMPTY The cyan ink tank in the printhead is empty. Replace the ink tank. p. 10-4 CARD READER BUSY You tried to start photo printing Wait until the card slot is no longer when the card slot was in use by being used by the computer. the computer. CARD READER ERROR There is a problem with the card Try switching to another mode or slot. turning the machine off and on. If the message remains, contact the Canon Customer Care Center. CARD READER OFFLINE The card slot may not be receiving any power. Remove the memory card from the p. 5-1 card slot, turn the power off and on again, then reinsert the memory card. CARTRIDGE JAMMED The printhead holder cannot move. This is normally due to a paper jam. Clear the paper jam or whatever is p. 11-15 obstructing the printhead holder and then press [Resume]. Do not attempt to move the printhead holder manually. Fax Model CHANGE PAPERSIZE:FAX The paper size setting is set to a Set the paper size setting to letter, size other than letter, legal, or A4. legal, or A4 and load paper of the same size. The received fax will then be printed automatically. p. 2-7 11-18 Troubleshooting Chapter 11