HP D5970A HP Netserver LXr 8000 to LXr 8500 Upgrade Guide - Page 48
Install the Midplane Board and Center Support
View all HP D5970A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 48 highlights
Chapter 5 Assembling the LXr 8500 Install the Midplane Board and Center Support 1b. Orient the midplane board so that: - the notches point down - the peripheral bay power connector faces the front of the NetServer 1c. Angle the midplane as you insert it, then fasten all four screws. Figure 5-1. Install Midplane 1. Locate the LXr 8500 midplane board and install it as follows (see Figure 5-1): a. Move the peripheral bay cables out of the way. b. Orient the midplane board so that the notches in the sheet metal point down, and the peripheral bay power connector faces the front of the NetServer. c. Angle the midplane board as you insert it, then rotate it to the vertical position. The three connectors on the midplane board line up with openings in the sheet metal leading to the power supplies. d. Fasten the four screws. 42