HP D5970A HP Netserver LXr 8000 to LXr 8500 Upgrade Guide - Page 58
Install the Remote Control
View all HP D5970A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 58 highlights
Chapter 5 Assembling the LXr 8500 11. Press the center of the PCI hold-down latch in Slot 2. Then swing it back out of the way. Figure 5-11. Open the PCI Hold-down Latch in Slot 2 11. Locate Slot 2 on the I/O baseboard (see Figure 5-8) and open the PCI hold-down latch. (See Figure 5-11.) 12. Install the Remote Control card in Slot 2. 13. The Remote Control card cable passes over the top of the slot dividers and connects to J1F1 on the I/O baseboard. Figure 5-12. Install the Remote Control Card 12. Install the remote control card (RCC) in Slot 2. (See Figure 5-12.) 13. Connect the RCC cable to the connector labeled J1F1 on the I/O baseboard. 52
Chapter 5
Assembling the LXr 8500
52
11. Press the center of the
PCI hold-down latch in
Slot 2. Then swing
it back out of the way.
Figure 5-11. Open the PCI Hold-down Latch in Slot 2
11.
Locate Slot 2 on the I/O baseboard (see Figure 5-8) and open the PCI
hold-down latch. (See Figure 5-11.)
12. Install the Remote Control
card in Slot 2.
13. The Remote Control
card cable passes over the
top of the slot dividers and
connects to J1F1 on the I/O
baseboard.
Figure 5-12. Install the Remote Control Card
12.
Install the remote control card (RCC) in Slot 2. (See Figure 5-12.)
13.
Connect the RCC cable to the connector labeled J1F1 on the I/O
baseboard.