HP D5970A HP Netserver LXr 8000 to LXr 8500 Upgrade Guide - Page 56
Open = Off, Front of NetServer, Closed = On, Rear of NetServer
View all HP D5970A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 56 highlights
Chapter 5 Assembling the LXr 8500 8. Check the I/O configuration switches on the I/O baseboard. By default all of the switches are set in the "Open" (or "Off") position, and normally do not have to be changed. See Figure 5-9. Rear of NetServer 1 Reserved 2 Recovery Boot Open 3 Reserved 4 Reserved 5 CMOS Clear 6 Password Clear Shaded rectangle 7 PCI Hot-Plug Switch Disable represents the 8 Reserved depressed side of the configuration Front of NetServer switch Open = Off Closed = On Figure 5-9. I/O Configuration Switch Settings 50
Chapter 5
Assembling the LXr 8500
50
8.
Check the I/O configuration switches on the I/O baseboard. By default all
of the switches are set in the "Open" (or "Off") position, and normally do
not have to be changed. See Figure 5-9.
Open = Off
Front of NetServer
Shaded rectangle
represents the
depressed side
of the configuration
switch
Closed = On
Rear of NetServer
1
Reserved
Open
2
Recovery Boot
3
Reserved
4
Reserved
5
CMOS Clear
6
Password Clear
7
PCI Hot-Plug Switch Disable
8
Reserved
Figure 5-9. I/O Configuration Switch Settings