Canon imageCLASS MF7460 imageCLASS MF7400 Series Basic Operation Guide - Page 317

Message Description Action Place the original on the platen glass. The specified mode requires that the original be placed on the platen glass, but there is no original on the platen glass. Place the original on the platen glass. Platen Glass is dirty. The feeder's scanning area is dirty. Clean the feeder's scanning area. (See "Manual Feeder Cleaning," on p. 10‑7.) Remove the original from the feeder. The machine cannot scan your original using the feeder. An original is placed in the feeder and on the platen glass. Remove the original from the feeder. Remove the paper from the Prints from the previous job output tray. remain in the output tray. Remove the prints remaining in the output tray. Printing automatically resumes. Replace the toner. Printing is not possible because Replace the cartridge. (See the toner has run out. "Replacing the Cartridge," on p. 10‑14.) Return page 1 to the top, and then press the Start key. Scanning was stopped due to a problem with the feeder. Arrange the originals in page order with the first page on top. Place the originals back into the feeder's original supply tray, and press (Start). Set the IP Address. (imageCLASS MF7480/ MF7470 Only) This machine is not set with an IP address. Specify the IP Address Settings in TCP/IP Settings in Network Settings in System Settings (from the Additional Functions screen), then turn the machine's main power off and back on again. (See Chapter 6, "Network (imageCLASS MF7480/MF7470 Only)," in the Reference Guide, or "Set the Machine for Network Usage (imageCLASS MF7480/MF7470 Only)," in the Starter Guide.) There are too many subdirectories. You have exceeded the maximum number of subdirectory levels allowed. The directory level that you are trying to access cannot be specified. Specify a different destination. Troubleshooting 11‑20