Cisco 7970G Administration Guide - Page 79
Installing the Cisco Unified IP Phone - upgrade firmware
UPC - 746320926292
View all Cisco 7970G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 79 highlights
Chapter 3 Setting Up the Cisco Unified IP Phone Installing the Cisco Unified IP Phone • Move the external device away from the source of the RF or AF signals. • Route the external device cables away from the source of the RF or AF signals. • Use shielded cables for the external device, or use cables with a better shield and connector. • Shorten the length of the external device cable. • Apply ferrites or other such devices on the cables for the external device. Cisco cannot guarantee the performance of the system because Cisco has no control over the quality of external devices, cables, and connectors. The system will perform adequately when suitable devices are attached using good quality cables and connectors. Caution In European Union countries, use only external headsets that are fully compliant with the EMC Directive [89/336/EC]. Installing the Cisco Unified IP Phone You must connect the Cisco Unified IP Phone to the network and to a power source before using it. See Figure 3-2 for a graphical representation of the connections. Note Before you install a phone, even if it is new, upgrade the phone to the current firmware image. Before using external devices, read the "Using External Devices with Your Cisco Unified IP Phone" section on page 3-6 for safety and performance information. Before You Begin Remove the hookswitch clip (see the "Handset" section on page 3-4) from the cradle area. To install a Cisco Unified IP Phone, perform the following steps: Cisco Unified IP Phone 7970G/7971G-GE Administration Guide for Cisco Unified Communications Manager 6.1 OL-14626-01 3-7