Cisco SPA1001 Administration Guide - Page 149

Chapter 5 Linksys ATA Field Reference User 1/2 Tab User 1/2 Tab This section describes the fields for the following headings on the User 1 and User 2 tabs: • Call Forward Settings, page 5-65 • Selective Call Forward Settings, page 5-66 • Speed Dial Settings, page 5-67 • Supplementary Service Settings, page 5-67 • Distinctive Ring Settings, page 5-68 • Ring Settings, page 5-68 User 1/2 refers to the subscriber of Line 1 or Line 2. Note For the SPA8000, the settings on this page occur on each Line tab ([1] to [8]). When a call is made from Line 1 or Line 2, Linksys IP phone shall use the user and line settings for that Line; there is no user login support in Linksys IP phone v1.0. Per user parameter tags must be appended with [1] or [2] (corresponding to line 1 or 2) in the configuration profile. It is omitted below for readability. Note References in this section to the SPA3102 also apply to the AG310. Call Forward Settings Field Cfwd All Dest Cfwd Busy Dest Description Forward number for Call Forward All Service In addition to normal call forward destination as used in the other ATAs, on the SPA3102, you can specify the following additional parameters: • gw0 - forward the caller to use the PSTN gateway • @gw0 - forward to caller to the PSTN number (dialed automatically by the SPA through the PSTN gateway) The default is blank. Forward number for Call Forward Busy Service. Same as Cfwd All Dest. The default is blank. Document Version 3.2 Linksys IP Phone Administrator Guide 5-65