Compaq ProLiant 1600 Compaq ProLiant 1600 and ProLiant 1200 Servers Maintenanc - Page 30
Hot-Plug Drive Cage
View all Compaq ProLiant 1600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 30 highlights
2-12 Removal and Replacement Procedures Hot-Plug Drive Cage To remove the hot-plug drive cage: 1. Perform the preparation procedures. See page 2-2. 2. Remove the front bezel. See page 2-6. 3. Remove the left side access panel. See page 2-8. 4. Disconnect all cables from the hot-plug drive cage. 5. Remove the four T-15 screws. 6. Slide the hot-plug drive cage out the front of the chassis. Figure 2-7. Removing the Hot-Plug Drive Cage CAUTION: Make sure that all power and signal cables to the hot-plug drive cage have been reseated properly. Reverse steps 1 through 6 to replace the hot-plug drive cage.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
.
2-12
Removal and Replacement Procedures
Hot-Plug Drive Cage
To remove the hot-plug drive cage:
1.
Perform the preparation procedures. See page 2-2.
2.
Remove the front bezel. See page 2-6.
3.
Remove the left side access panel. See page 2-8.
4.
Disconnect all cables from the hot-plug drive cage.
5.
Remove the four T-15 screws.
6.
Slide the hot-plug drive cage out the front of the chassis.
Figure 2-7.
Removing the Hot-Plug Drive Cage
CAUTION:
Make sure that all power and signal cables to
the hot-plug drive cage have been reseated properly.
Reverse steps 1 through 6 to replace the hot-plug drive cage.