Compaq ProLiant 1600 Compaq ProLiant 1600 and ProLiant 1200 Servers Maintenanc - Page 53
Backplane Board, The Compaq ProLiant 1600 backplane board has two SCSI connectors. The Compaq
View all Compaq ProLiant 1600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 53 highlights
2-35 Backplane Board The Compaq ProLiant 1600 backplane board has two SCSI connectors. The Compaq ProLiant 1200 backplane board has one SCSI connector To remove the backplane board: 1. Perform the preparation procedures. See page 2-2. 2. Remove the top cover. See page 2-9. 3. Remove the left side access panel. See page 2-8. 4. Remove the system I/O board cage. See page 2-17. 5. Remove the processor cage. See page 2-21. 6. Disconnect all cables from the backplane board. 7. Remove the three T-15 screws from the backplane board. 8. Slide the backplane board down slightly and pull it from its mounting posts. Figure 2-32. Removing the Backplane Board Reverse steps 1 through 8 to replace the backplane board. Compaq ProLiant 1600 and ProLiant 1200 Servers Maintenance and Service Guide