Compaq ProLiant 1600 Compaq ProLiant 1600 and ProLiant 1200 Servers Maintenanc - Page 35
System I/O Board Cage, Remove the two security screws if installed.
View all Compaq ProLiant 1600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 35 highlights
2-17 System I/O Board Cage The system I/O board cage contains the system I/O board with PCI slots, system switches, EISA slots, and the battery. Four slots are PCI/EISA; two are PCI only, for a total of six slots. To remove the system I/O board cage: 1. Perform the preparation procedures. See page 2-2. 2. Remove the top cover. See page 2-9. 3. Disconnect all cables from the system I/O board cage. 4. Remove any installed boards. Place them on a non-conductive work surface. You will install them on the replacement system I/O board cage. 5. Remove the two security screws (if installed). 6. Push down on the cage ejector lever , and pull out . 7. Pull the system I/O board cage out the back of the chassis . 1 2 3 Figure 2-14. Removing the System I/O Board Cage Reverse steps 1 through 7 to replace the system I/O board cage. Install any boards removed in step 4 onto the replacement system I/O board cage. Compaq ProLiant 1600 and ProLiant 1200 Servers Maintenance and Service Guide