Compaq ProLiant 8500 ProLiant 8500 Servers Maintenance and Service Guide - Page 140
The following ASR-2 flow chart shows you the sequence of events after a hardware or software
View all Compaq ProLiant 8500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 140 highlights
3-62 Compaq ProLiant 8500 Server Maintenance and Service Guide The following ASR-2 flow chart shows you the sequence of events after a hardware or software error occurs. Hardware/Software error occurs. | Error is recorded in the Critical Error Log or the Integrated Management Log, depending on the server configuration. | Operating system halts normal operation. | ASR timer expires. | Server is reset. | If a modem is installed and paging is enabled, the Server Failure Notification pager alert is sent to the Server Administrator. | Unattended server starts the operating system. ---Or--- Server starts the Compaq utilities from the system partition on the hard drive. | If the server continues to experience hardware/software errors and the number of ASR cycles exceeds the specified number of recovery attempts, the server logs an error to the Server Health Log or the Integrated Management Log and starts the Compaq utilities from the system partition on the hard drive. | If a modem is installed, ASR puts the modem on auto-answer so that the Server Administrator can dial in (using third-party terminal emulator software) to remotely run the Compaq utilities to identify the source of the fault. | Or | Local server administrator runs Compaq utilities from server console to identify the source of the fault. Figure 3-1. ASR-2 flow chart