Compaq ProLiant 8500 ProLiant 8500 Servers Maintenance and Service Guide - Page 57
I/O Module, Removing the I/O Module from Tower Model Servers
View all Compaq ProLiant 8500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 57 highlights
2-34 Compaq ProLiant 8500 Server Maintenance and Service Guide I/O Module The I/O module is located at the rear of the server. Remove it to replace or service non-hot-pluggable components or to access other components in the I/O module. Removing the I/O Module from Tower Model Servers To remove the I/O module: 1. Perform the preparation procedures. See "Preparation Procedures" earlier in this chapter. 2. Open the top access panel. See "Top Access Panel" earlier in this chapter. 3. Loosen the shipping screw, if necessary. See "Shipping Screw" earlier in this chapter. 4. Push in on the sides of the stop latches on the I/O module, and rotate the cam levers downward . 5. Pull the I/O module out of the chassis until it catches on the module stop latch. 1 2 3 Figure 2-25. Partially removing the I/O module