Compaq ProLiant 8500 ProLiant 8500 Servers Maintenance and Service Guide - Page 48
CAUTION, IMPORTANT, Press outward on the socket latches at each end of the DIMM
View all Compaq ProLiant 8500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 48 highlights
Removal and Replacement Procedures 2-25 To remove a DIMM: 1. Perform the preparation procedures. See "Preparation Procedures" earlier in this chapter. 2. Remove the processor and memory module drawer. See "Opening and Removing the Processor and Memory Module" earlier in this chapter. 3. Remove the memory board. See "Media Module" earlier in this chapter. 4. Press outward on the socket latches at each end of the DIMM . 5. Remove the DIMM from the memory expansion board . 1 2 1 Figure 2-18. Removing a DIMM from the memory board Reverse steps 1 through 5 to replace a DIMM. CAUTION: The ejectors prevent the memory expansion board from lying completely flat. Inserting a DIMM without counter pressure applied behind the socket to the back of the expansion board can cause the memory expansion board to flex and could result in damage. Always support the memory expansion board or apply counter pressure while inserting a DIMM. IMPORTANT: Make sure that both latches are secured when the DIMM is installed.