Compaq ProLiant 8500 ProLiant 8500 Servers Maintenance and Service Guide - Page 40
To remove a hot-pluggable SCSI hard drive, Push the tab to unlock the drive
View all Compaq ProLiant 8500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 40 highlights
Removal and Replacement Procedures 2-17 CAUTION: Do not turn off an attached disk drive enclosure when the server containing the Smart Array Controller is powered on. Also, do not turn on the server before turning on the disk enclosure. If these ordering rules are not followed, the Smart Array Controller may mark the drives in this enclosure as "failed," which could result in permanent data loss. CAUTION: Replace a hot-pluggable SCSI hard drive only when the drive LED is amber. Do not remove a hot-pluggable SCSI hard drive if the online LED is green. To remove a hot-pluggable SCSI hard drive: 1. Push the tab to unlock the drive . 2. Rotate the hot-pluggable drive ejector lever outward . 3. Pull the hot-pluggable drive from the drive bay . 1 2 3 Figure 2-11. Removing a hot-pluggable SCSI hard drive Reverse steps 1 through 3 to replace a hot-pluggable SCSI hard drive.