D-Link DES-3026 Reference Manual - Page 97
Broadcast Storm Control Commands, config traffic control
UPC - 790069280771
View all D-Link DES-3026 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 97 highlights
DES-3000 Series Layer 2 Switch CLI Reference Manual 12 BROADCAST STORM CONTROL COMMANDS The broadcast storm control commands in the Command Line Interface (CLI) are listed (along with the appropriate parameters) in the following table. Command Parameters config traffic control [ | all] {broadcast [enable | disable] | multicast [enable | disable] | dlf [enable | disable] | threshold } show traffic control {group_list } Each command is listed, in detail, in the following sections. config traffic control Purpose Syntax Description Parameters Used to configure broadcast / multicast traffic control. config traffic control [ | all] {broadcast [enable | disable] | multicast [enable | disable] | dlf [enable | disable] | threshold } This command is used to configure broadcast storm control. − Used to specify a broadcast storm control group. The grouplist corresponds to the port number on the Switch. all − Specifies all broadcast storm control groups on the Switch. broadcast [enable | disable] − Enables or disables broadcast storm control. multicast [enable | disable] − Enables or disables multicast storm control. dlf [enable | disable] − Enables or disables dlf traffic control. Restrictions threshold − The upper threshold at which the specified traffic control is switched on. The value is the amount of broadcast/multicast/dlf traffic, in Kbps, received by the Switch that will trigger the storm traffic control measures. The value ranges in size from 64 to 1024000 Kpps. Only administrator-level users can issue this command. Example usage: To configure traffic control and enable broadcast storm control system wide: DES-3026:4# config traffic control all broadcast enable Command: config traffic control all broadcast enable Success. DES-3026:4# 93