Dell 2150cn User Manual - Page 302

IP Filter NOTE: IP Filter feature is available only for LPD or Port9100. Purpose: To block data received from certain IP addresses through the wired or wireless network. You can set up to five IP addresses. The change becomes effective after the printer is turned off and then on again. Values: No. n / Address (n is 1-5.) Sets the IP address for Filter n. No. n / Mask (n is 1-5.) No. n / Mode (n is 1-5.) Off* Sets the address mask for Filter n. Disables the IP Filter feature for Filter n. Accept Accepts an access from the specified IP address. Reject Rejects an access from the specified IP address. IEEE 802.1x NOTE: IEEE 802.1x feature is available only when the printer is connected using LAN cable and it is available only when the IEEE 802.1 authentication is enabled. Purpose: To disable IEEE 802.1x authentication. The change becomes effective after the printer is turned off and then on again. Values: Disable Disables IEEE 802.1x. Reset LAN Purpose: To initialize wired network data stored in non-volatile memory (NVM). After executing this function and rebooting the printer, all wired network settings are reset to their default values. Values: Are You Sure? Press the in NVM. (Set) button to initialize the wired network data stored 300 Understanding the Printer Menus