Dell C3760DN Color Laser User Manual - Page 199

IP Filter NOTE: IP Filter feature is available only for LPD or Port9100. Purpose: To block data received from certain IP addresses through the wired or wireless network. You can set up to five IP addresses. The change becomes effective after the printer is turned off and then on again. Values: No. n / IP Address (n is 1-5.) No. n / Mask (n is 1-5.) No. n / Mode (n is 1-5.) Off* Accept Reject Sets the IP address for Filter n. Sets the address mask for Filter n. Disables the IP Filter feature for Filter n. Accepts an access from the specified IP address. Rejects an access from the specified IP address. IEEE 802.1x NOTE: IEEE 802.1x feature is available only when the printer is connected using LAN cable and it is available only when the IEEE 802.1x authentication is enabled. Purpose: To disable IEEE 802.1x authentication. The change becomes effective after the printer is turned off and then on again. Reset LAN Purpose: To initialize wired network data stored in non-volatile memory (NVM). After executing this function and rebooting the printer, all wired network settings are reset to their default values. Adobe Protocol Purpose: To specify PostScript communication protocol for a parallel interface, you can configure the Adobe Protocol settings for the wired network. The change becomes effective after the printer is turned off and then on again. Values: Auto Standard BCP TBCP* Binary Used when auto-detecting the PostScript communication protocol. Used when the communication protocol is in ASCII interface. Used when the communication protocol is in binary format. Used when the communication protocol supports both ASCII and binary data to switch between them according to the specified control code. Used when no special processing is required for data. USB Settings Use the USB Settings menu to change printer settings affecting a USB port. USB Port NOTE: USB Port feature is available only for the USB port on the rear of the printer. Understanding the Printer Menus 197