Dell C3760DN Color Laser User Manual - Page 200
System Settings
View all Dell C3760DN Color Laser manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 200 highlights
Purpose: To specify whether to enable the USB port. The change becomes effective after the printer is turned off and then on again. Values: Disable Enable* Disables the USB interface. Enables the USB interface. Adobe Protocol Purpose: To specify PostScript communication protocol for a parallel interface, you can configure the Adobe Protocol settings for the wired network. The change becomes effective after the printer is turned off and then on again. Values: Auto Standard BCP TBCP* Binary Used when auto-detecting the PostScript communication protocol. Used when the communication protocol is in ASCII interface. Used when the communication protocol is in binary format. Used when the communication protocol supports both ASCII and binary data to switch between them according to the specified control code. Used when no special processing is required for data. System Settings Use System Settings to configure the power saving mode, warning tones, time-out duration, display language, and job log auto print settings. NOTE: Values marked by an asterisk (*) are the factory default menu settings. Power Saver Timer CAUTION: If the Auto-Off Timer feature is set and the power is turned off, stored data in RAM Disk is cleared. Purpose: To specify the time for transition to power saver mode. Values: Sleep 6 minutes* Deep Sleep Available Range: 1-60 minutes 8 minutes* Auto-Off Timer*1 Available Range: 1-60 minutes Off* On 180 minutes* Available Range: 60-1440 minutes *1 Auto-Off Timer feature is available only in certain regions. Specifies the time taken by the printer to enter Sleep mode after it finishes a job. Specifies the time taken by the printer to enter Deep Sleep mode after it has entered Sleep mode. Disables the Auto-Off Timer. Specifies the time it takes to automatically turn off the printer after it has entered Deep Sleep mode. When you specify 1 minute for Sleep, the printer enters power saver mode 1 minute after it finishes a job. This uses much less energy, but requires more warm-up time for the printer. Specify 1 minute if your printer shares an electrical circuit with room lighting and you notice lights flickering. 198 Understanding the Printer Menus