HP 8/80 Converged Enhanced Ethernet Command Reference v6.4.0 (53-1001762-01, J - Page 155
protocol spanning-tree, Specifies the Spanning Tree Protocol STP.
View all HP 8/80 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 155 highlights
DRAFT: BROCADE CONFIDENTIAL protocol spanning-tree 9 protocol spanning-tree Synopsis Operands Defaults Command Modes Description Usage Guidelines Examples See Also protocol spanning-tree [mstp|rstp|stp] no protocol spanning-tree mstp rstp stp Specifies the Multiple Spanning Tree Protocol (MSTP). Specifies the Rapid Spanning Tree (RSTP). Specifies the Spanning Tree Protocol (STP). By default, STP is not enabled. STP is not required in a loop-free topology. Global configuration mode Use this command to create a context for the protocol specified. Use the no protocol spanning-tree command to delete the context and all the configurations defined within the context or protocol for the interface. Consider enabling STP to detect or avoid loops. You must turn off one form of STP before turning on another form. Packet drops or packet flooding may occur if you do not enable xSTP on all devices connected on both sides of parallel links. To enable the Spanning Tree Protocol: switch(config)#protocol spanning-tree stp show spanning-tree Converged Enhanced Ethernet Command Reference 137 53-1001762-01