HP 8/80 Converged Enhanced Ethernet Command Reference v6.4.0 (53-1001762-01, J - Page 66
switchport
View all HP 8/80 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 66 highlights
3 switchport DRAFT: BROCADE CONFIDENTIAL switchport Synopsis Operands Defaults Command Modes Description Usage Guidelines Examples See Also Puts the interface to Layer 2 mode and sets the switching characteristics of the Layer 2 interface to the defaults. switchport no switchport none By default, all Layer 2 interfaces are mapped to default VLAN 1 and the interface is set to access mode. Interface configuration mode Use this command to set the switching characteristics of the Layer 2 interface. Use the no switchport command to take the switch out of the Layer 2 mode. For changing the interface configuration mode to trunk or changing the default VLAN mapping, use additional switchport commands. To put an interface in Layer 2 mode: switch(conf-if-te-0/1)#switchport To remove an interface from Layer 2 mode: switch(conf-if-te-0/1)#no switchport show vlan brief, show interface switchport, switchport mode, switchport access, switchport trunk 48 Converged Enhanced Ethernet Command Reference 53-1001762-01