HP 8/80 Converged Enhanced Ethernet Command Reference v6.4.0 (53-1001762-01, J - Page 238
dot1x quiet-period, Synopsis, dot1x quiet-period interval, Operands, interval, Defaults, Command
View all HP 8/80 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 238 highlights
13 dot1x quiet-period DRAFT: BROCADE CONFIDENTIAL dot1x quiet-period Synopsis Operands Defaults Command Modes Description Usage Guidelines Examples See Also Sets the number of seconds that a switch remains quiet between a failed authentication and an attempt to retry authentication. dot1x quiet-period interval seconds no dot1x quiet-period interval seconds Specifies the time in seconds between attempts at authentication. The range of valid values is 1-65535. The default time is 60 seconds. Interface configuration mode Use this command to set the time in seconds after which a switch attempts to perform authentication after a failed authentication. Use the no dot1x quiet-period command to return to the default setting. When a switch cannot authenticate a client, the switch remains idle for a quiet-period interval of time, then attempts the operation again. Changing the quiet-period interval time to a number lower than the default can result in a faster response time. To change the interval time to 200 seconds: switch(config)#interface tengigabiethernet 0/1 switch(conf-if-te-0/1)#dot1x quiet-period 200 none 220 Converged Enhanced Ethernet Command Reference 53-1001762-01