HP Deskwriter 600 DeskWriter 600 User's Guide - Not Orderable - Page 44
Tip: Using Non-Standard Size Paper
View all HP Deskwriter 600 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
USING PAPER, CARDS, ENVELOPES, LABELS, AND TRANSPARENCIES Tip: Using Non-Standard Size Paper The printer driver provided with the HP DeskWriter 600 printer does not provide settings for non-standard paper sizes. Paper sizes that are considered non-standard are those with a width between 5 and 8.5 inches (127 and 215 mm) and a length between 5.83 and 14 inches (148 and 356 mm). In general, to use non-standard paper sizes, first set up your software application for a page size that is the same as or smaller than the paper now in the printer. Then, in Page Setup, select the paper size that is one size larger in both directions than the paper now in the printer. For more precise control of printing on non-standard size papers, use the following steps. 1. Slide the paper width adjuster to its leftmost position. 2. Pull out the paper length adjuster and remove any paper from the IN tray. Paper Width Adjuster Paper Length Adjuster 2184037 N OT E Make sure the card guide (used when printing on index cards and postcards) is in the down position. (See the drawing on page 31 in the procedure Using Index Cards and Postcards for the location of the card guide.) 3. Remove up to a 1/2 inch (1 cm) stack of paper from its package and tap the short edge of the stack on a flat surface to even the stack. 39