HP ML330 HP ProLiant ML330 Generation 3 Server Setup and Installation Guide - Page 129
Press outward on the latch at the top of the battery holder to release the, To replace the component
UPC - 613326960790
View all HP ML330 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 129 highlights
Battery Replacement 4. Locate the battery on the system board. Refer to Chapter 1, "Component Identification." NOTE: If you have expansion boards installed, it may be necessary to remove them to gain access to the battery. Refer to Chapter 4, "Hardware Options Installation." 5. Remove the battery: a. Press outward on the latch at the top of the battery holder to release the battery. b. Lift the battery away from the holder. To replace the component, reverse the removal procedure. IMPORTANT: Replacing the system board battery resets the system ROM to its default configuration. After replacing the battery, reconfigure the system through RBSU. Refer to Chapter 5, "Server Configuration and Utilities." For more information about battery replacement or proper disposal, contact the authorized reseller or authorized service provider. F-2 HP ProLiant ML330 Generation 3 Server Setup and Installation Guide