HP ML330 HP ProLiant ML330 Generation 3 Server Setup and Installation Guide - Page 60
ATA Cabling, channels. Do not connect other peripherals to the Integrated ATA/100 RAID
UPC - 613326960790
View all HP ML330 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 60 highlights
Hardware Options Installation 3. Connect the next available SCSI cable connector to the hard drive or SCSI device. 4. Connect the next available power cable connector to the hard drive or SCSI device. ATA Cabling Observe the following guidelines when adding ATA hard drives to the server: • A maximum of two hard drives may be added per channel. The server is equipped with two integrated ATA/100 RAID channels. • Jumpers on ATA devices should be set to Cable Select (CS), enabling primary and secondary devices to be determined by the cable. • Connect ATA hard drives only to the Integrated ATA/100 RAID controller channels. Do not connect other peripherals to the Integrated ATA/100 RAID controller channels. To cable an ATA hard drive: 1. Complete the hardware installation procedure. 2. Connect the end of the ATA cable to the system board. HP ProLiant ML330 Generation 3 Server Setup and Installation Guide 4-17