HP ML330 HP ProLiant ML330 Generation 3 Server Setup and Installation Guide - Page 131

Index SCSI controller 1-13 system board 1-8 configuring the server 3-10 connectors rear panel 1-6 system board 1-8 controllers, boot order 5-4 cord See power cord current, rating A-9 D date and time battery replacement F-1 setting 5-4 declaration of conformity A-3 default switch settings 1-9 devices connection tips 6-9 jumper settings 1-10 power-up sequence D-2 diagnosing problems See troubleshooting diagnostic tools 5-13 diagnostics utility 5-14 dimensions, server E-1 DIMM failure LEDs 1-12 DIMM slots, location 1-8 DIMMs, installing 4-5 disk mirroring 6-2 disk striping 6-1 diskette boot control 5-3 diskette drive connector, system board 1-8 dimensions 1-5 eject button 1-2 LED 1-3 locating 1-5 write control, setting 5-3 diskette write control, RBSU 5-3 disposal, battery A-8 DMA transfers, enabling 6-6 drive tray rails, removing 4-20 drivers 5-14 E electrical requirements rack server 3-5 tower server 3-2 electrostatic discharge B-1 Enterprise Diagnostics LX32 Utility 5-14 equipment Class A A-2 Class B A-2 error messages C-1 European Union equipment compliance A-4 expansion board retainer 4-28 expansion boards, installing 4-27 expansion slots, location 1-8 F fan failure LEDs 1-11 FCC See Federal Communications Commission (FCC) features 1-1 Federal Communications Commission (FCC) compliance notice, Class A A-2 compliance notice, Class B A-2 declaration of conformity A-3 notice A-1 requirements A-3 rules A-2, A-3 firmware, upgrading 5-11 flash ROM 5-11 front bezel, removing and replacing 2-2 front panel components 1-2 LEDs 1-3 G grounding methods B-2 Index-2 HP ProLiant ML330 Generation 3 Server Setup and Installation Guide