HP ML330 HP ProLiant ML330 Generation 3 Server Setup and Installation Guide - Page 65
Installing a Two-Bay Hot-Plug SCSI Drive Cage, Remove the bezel from the drive cage.
UPC - 613326960790
View all HP ML330 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 65 highlights
Hardware Options Installation Installing a Two-Bay Hot-Plug SCSI Drive Cage NOTE: For additional information about the two-bay hot-plug SCSI drive cage, refer to the HP Internal Two-Bay Hot-Plug SCSI Drive Cage Installation Instructions. To install the two-bay hot-plug SCSI drive cage: 1. Complete the "Preparation Procedures" in this chapter. 2. Remove the bezel that ships attached to the drive cage: a. Use a Torx T-10 tool to loosen the two screws. b. Remove the screws from the bezel. c. Remove the bezel from the drive cage. IMPORTANT: Be sure that the unit identification numbers (0 and 1) appear on the right side of the drive cage front panel. For identification purposes, the number 2 appears on the back of the bezel shipped with the option kit. 3. Reverse the actions in step 1 to install the smaller bezel from the option kit on the drive cage. 4-22 HP ProLiant ML330 Generation 3 Server Setup and Installation Guide