HP ML330 HP ProLiant ML330 Generation 3 Server Setup and Installation Guide - Page 23
System ID Switch, Jumper Settings, SCSI Device Jumper Settings
UPC - 613326960790
View all HP ML330 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 23 highlights
Component Identification System ID Switch The system ID switch is reserved for use by authorized service providers only. Do not change the indicated default settings. Jumper Settings SCSI Device Jumper Settings No two SCSI devices connected to the same SCSI controller can have the same SCSI ID. If another SCSI device is connected to the controller, check its SCSI ID before beginning the installation procedure for the additional device. Jumpers located on each device set the SCSI ID. For more information, refer to the SCSI device option documentation. IDE Device Jumper Settings When installing any IDE devices (ATA hard drives, ATAPI CD-ROM drives, or ATAPI tape drives), be sure that the jumper on the device is set to Cable Select (CS). This setting allows the cable to automatically assign the device ID of an IDE drive attached to the cable. For information on installing and cabling IDE devices, refer to Chapter 4, "Hardware Options Installation." 1-10 HP ProLiant ML330 Generation 3 Server Setup and Installation Guide