HP StorageWorks 4/16 Brocade OS Command Reference Manual Supporting Fabric OS - Page 304
Fabric OS Administrator's Guide, These features are available only
View all HP StorageWorks 4/16 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 304 highlights
2 interopMode In v6.0.0, when McDATA Fabric interoperability mode is turned on, the OUI portion of the switch WWN is no longer replaced with a McDATA OUI. The Brocade OUI will be used. However, upgrading from FOS 5.2.1_NI to FOS 6.0.0 will be non-disruptive, preserving the McDATA OUI and the given interopMode. Unless the switch is taken offline, and the interopMode is changed, or the OUI is changed with the configure command, the McDATA OUI will be preserved. When interoperability mode is disabled, all configuration parameters return to their default states and can be modified using the configure command. For information on supported hardware platforms and procedures regarding OS v5.2.2_NI to v6.0.0 migration, refer to the Fabric OS Administrator's Guide. Operands When invoked without operands, the command displays the current mode and usage. The following operands are optional: mode Specify "0" to disable interoperability mode. Specify "2" to enable McDATA Fabric mode. Specify "3" to enable McDATA Open Fabric mode Use the following operands to set McDATA zoning features. These features are available only in McDATA Fabric Mode (interopMode 2): McDATA Default Zone and McDATA Safe Zone are fabric-wide features. If one of these features is enabled on one switch, it has to be enabled on all other switches. Otherwise the E_port is segmented. Enabling or disabling the McDATA Zoning does not require a reboot. -z Default Zone Specify "1" to enable the McDATA default zone feature. Specify "0" to disable the McDATA default zone feature. -s Safe Zone Specify "1" to enable the McDATA Safe Zone feature. Specify "0" to disable the McDATA Safe Zone feature. Examples Executing the interopMode command without operands displays the current mode and command usage. To enable McDATA Open Fabric mode: switch:admin> interopmode InteropMode: McDATA Fabric Default Zone: Off Safe Zone: On usage: InteropMode [0|2|3 [-z McDataDefaultZone] [-s McDataSafeZone]] 0: to turn interopMode off 2: to turn McDATA Fabric mode on Valid McDataDefaultZone: 0 (disabled), 1 (enabled) Valid McDataSafeZone: 0 (disabled), 1 (enabled) 3: to turn McDATA Open Fabric mode on To turn Safe Zone on while in interopmode 2: switch:admin> interopMode 2 -s 1 InteropMode: McDATA Fabric Default Zone: Off Safe Zone: On 278 Fabric OS Command Reference 53-1000599-01