HP StorageWorks 4/16 Brocade OS Command Reference Manual Supporting Fabric OS - Page 535
bandwidth rate, SACK status, Minimum Retransmit time, Keepalive Timeout
View all HP StorageWorks 4/16 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 535 highlights
portShow 2 Operands The third column shows the number of F_RJTs and F_BSYs generated. For L_Ports, the third column also displays the number of loop initialization protocols (LIPs) received, number of LIPs transmitted, and the last LIP received. The execution of this command is subject to Admin Domain restrictions that may be in place. This command supports the following port options: slot For bladed systems only, specify the slot number of the port to be configured, followed by a slash (/). [ge]port Specify the port number to be displayed, relative to its slot for bladed systems. For GigE ports, the ports are numbered ge0 - ge1. See switchShow for a list of valid ports. Use portShow with one of the following options and optional arguments, to display specific FCIP related parameters configured for a gigabit Ethernet port. all | tunnel_id For FCIP related command options only, specify all to display all FCIP tunnels or tunnel_id (0-7) to display a single FCIP tunnel. arp Displays address resolution protocol (ARP) table. When used with the lmac option, the local MAC address is displayed. fciptunnel Displays FCIP tunnel IDs, remote and local IP addresses, remote and local WWNs, compression status, FCIP fastwrite status, Tape Pipelining status, bandwidth rate, SACK status, Minimum Retransmit time, Keepalive Timeout, Maximum Retransmissions, DSCP Marking, tunnel status, tunnel uptime. Refer to portCfg help for an explanation of these parameters. Additional optional arguments for fciptunnel include: -perf Displays additional performance information. -params Displays connection parameter information. -credits Displays FC data path credit data. -ipsec Displays IKE and IPSec policy information on IPSec-enabled tunnels.Security policies are configured with the portCfg command. -qosmap Displays the mapping table for VC to FCIP QoS. ipif Displays the IP interface ID, IP address, netmask, and MTU for IPv4 addresses. Displays prefix instead of netmask for IPv6 addresses. iproute Displays the IP address, netmask, gateway, metrics, and flags.Displays prefix instead of netmask for IPv6 addresses. iscsi Displays GbE port WWN and ISCSI Sessions. mode Displays mode of GbE port. FCIP or not configured. ficon Displays FICON emulation configuration parameters. The syntax for this command is as follows: portshow ficon [Slot/]GePort all | tunnelId [Arg] [parm] [-clear] The following arguments are supported: -globals Displays general FICON Controls/Statistics. -images Displays discovered Images(FCUB). Fabric OS Command Reference 509 53-1000599-01