HP StorageWorks 4/16 Brocade OS Command Reference Manual Supporting Fabric OS - Page 464
portCfgEXPort, domain ID received becomes the subsequent preferred domain ID
View all HP StorageWorks 4/16 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 464 highlights
2 portCfgEXPort portCfgEXPort Sets a port to be an EX_Port, and sets and displays EX_Port configuration parameters. Synopsis portcfgexport [slotnumber/]portnumber portcfgexport [-a admin] portcfgexport [-f fabricid] portcfgexport [-r ratov] portcfgexport [-e edtov] portcfgexport [-d domainid] portcfgexport [-p pidformat] portcfgexport [-t fabric_parameter] portcfgexport [-m port mode] Description Use this command to allow a port to be configured as an EX_Port, to display the port's EX_Port configuration, or to change the configuration. If no optional parameter is specified, the command displays the currently configured values; otherwise, it sets the specified attribute to its new value. The port must be disabled prior to setting EX_Port attributes. The port must be enabled before the port can become active following EX_Port parameter changes. Use portDisable and the portEnable to disable/enable the port. IPFC over FCR allows the routing of IPFC traffic between different EX-Ports in the case where EX-Ports are connected to an edge fabric that has IPFC capable devices. IPFC traffic is routed between EX and VEX Ports. IPFC traffic can be related to the same edge fabric or to different edge fabrics. When the port is not active, the preferred domain ID is configurable. The preferred domain ID is used by the EX_Port's front phantom domain to request a domain ID from the principal switch. The domain ID received becomes the subsequent preferred domain ID, which is persistent and is displayed. When the port is not active, the preferred domain ID is configurable. The preferred domain ID is used by the EX_Port's front phantom domain to request a domain ID from the principal switch. The domain ID received becomes the subsequent preferred domain ID, which is persistent and is displayed. Notes The fabric ID must be the same for every router port connected to the same edge fabric, and different for every edge fabric. If two ports are connected to the same fabric but have been assigned different fabric IDs, one of them will be disabled due to a fabric ID oversubscription. If two fabrics have been assigned the same fabric ID, one of them will be disabled due to a fabric ID conflict. When a port is changed from FL_Port to EX_Port, the topology is implicitly changed to point-to-point. Front domain WWN field displays the WWN of the front domain. If the port is enabled and the state is "OK", the edge fabric principal switch's domain ID and WWN also are displayed. 438 Fabric OS Command Reference 53-1000599-01