IBM 8676 Hardware Maintenance Manual - Page 42
Windows, driver, messages
UPC - 087944770107
View all IBM 8676 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
Table 4. NetWare or IntraNetWare system ODI driver teaming messages for the Ethernet controller (continued) Message Description Requested number of Secondary cards are not found. Explanation: The number of adapters specified in the bind command could not be located. Action: Verify the numbers and slot locations of the adapters to be bound. If the problem remains, contact the network supplier. Failed to create AFT group. Make Explanation: Binding of protocol failed. Protocol is either not bound to any sure that the drivers for supported adapter or is bound to more than one adapter in the group. adapters are loaded, primary adapter is bound to protocols, and secondary Action: Ensure that the protocol is bound to only one adapter in an AFT adapter is not bound to any protocols. team. Error identifying slot numbers for the Explanation: The mapping between the board name entered and the slot specified board names. number for an adapter could not be established. Action: Check the board name for the adapter before issuing the bind command. If the problem remains, contact the network supplier. Cannot unbind specified slot from AFT group. Make sure that the slot you specified is for the primary adapter in an AFT group. Explanation: The number entered in the unbind command was not the primary adapter in an AFT group. Action: Reissue the unbind command and specify the slot number for the primary adapter. LAN adapter at slot nnnn (Port 0xaa) failed to reset. Check the state of the adapter. Explanation: The adapter that you specified could not be initialized. Action: 1. Load the driver for the supported adapter. 2. Check that the adapter is seated properly in the slot and try loading the AFT module again. If the problem remains, contact the network supplier. AFT is not supported on this version of NetWare. Explanation: The NetWare on the server is not a version supported by AFT. Action: Load and bind AFT only on supported versions of NetWare (currently version 5.1 and above). Failed to allocate resources tags. Explanation: An unknown error has occurred when trying to allocate needed resources for the AFT module. Please unload all LAN drivers before unloading AFT.NLM. Action: Check system configuration. If the problem remains, contact the network supplier. Explanation: An attempt was made to unload the AFT.NLM module before unloading the adapter driver. Action: Unload the adapter driver before unloading the AFT module. NDIS 4.0 (Windows NT) driver messages This section explains the error messages for the NDIS drivers. The explanation and recommended action are included with each message. Note: Although the term ″adapter″ is used in these messages, the messages might also apply to the integrated Ethernet controller on the system board. 32 xSeries 335 Type 8676, Type 8830: Hardware Maintenance Manual and Troubleshooting Guide