IBM 8676 Hardware Maintenance Manual - Page 81
Disconnect
UPC - 087944770107
View all IBM 8676 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 81 highlights
Power-cord module Power-cord module release a. Press down on the retention clip at the front of the power-cord module and slide the module toward the front of the server until the alignment tab is free of the slot on the side of the server. b. Lift the power-cord module out of the server as far as the power supply cable permits and set it aside. 5. Remove the DASD fan duct assembly located near the power supply (see illustration at "Replacing a fan assembly" on page 56). Attention: Prior to removing the power supply, ensure that the round USB cable and the flat ribbon cable are out of the way so as to avoid damage. 6. Remove the power supply: a. Disconnect the cables on the power supply. b. Remove the screw holding the power supply to the chassis and slide the power supply toward the front of the server until it disengages from the tabs on the floor of the chassis. To install the new power supply, reverse this procedure, making sure that all cables are routed correctly and do not block the air flow from the fan. Chapter 5. Service replaceable units 71