Intel E3300 Data Sheet - Page 72
Table 24., Signal Description, Sheet 9 of 10
View all Intel E3300 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 72 highlights
Land Listing and Signal Descriptions Table 24. Signal Description (Sheet 9 of 10) Name Type Description THERMTRIP# TMS TRDY# TRST# VCC VCCA VCCIOPLL VCCPLL VCC_SENSE VCC_MB_ REGULATION Output In the event of a catastrophic cooling failure, the processor will automatically shut down when the silicon has reached a temperature approximately 20 °C above the maximum TC. Assertion of THERMTRIP# (Thermal Trip) indicates the processor junction temperature has reached a level beyond where permanent silicon damage may occur. Upon assertion of THERMTRIP#, the processor will shut off its internal clocks (thus, halting program execution) in an attempt to reduce the processor junction temperature. To protect the processor, its core voltage (VCC) must be removed following the assertion of THERMTRIP#. Driving of the THERMTRIP# signal is enabled within 10 s of the assertion of PWRGOOD (provided VTT and VCC are asserted) and is disabled on de-assertion of PWRGOOD (if VTT or VCC are not valid, THERMTRIP# may also be disabled). Once activated, THERMTRIP# remains latched until PWRGOOD, VTT or VCC is de-asserted. While the deassertion of the PWRGOOD, VTT or VCC signal will de-assert THERMTRIP#, if the processor's junction temperature remains at or above the trip level, THERMTRIP# will again be asserted within 10 s of the assertion of PWRGOOD (provided VTT and VCC are valid). Input TMS (Test Mode Select) is a JTAG specification support signal used by debug tools. Input TRDY# (Target Ready) is asserted by the target to indicate that it is ready to receive a write or implicit writeback data transfer. TRDY# must connect the appropriate pins/lands of all FSB agents. Input TRST# (Test Reset) resets the Test Access Port (TAP) logic. TRST# must be driven low during power on Reset. Input VCC are the power pins for the processor. The voltage supplied to these pins is determined by the VID[7:0] pins. Input VCCA provides isolated power for internal PLLs on previous generation processors. It may be left as a No-Connect on boards supporting the processor. Input VCCIOPLL provides isolated power for internal processor FSB PLLs on previous generation processors. It may be left as a No-Connect on boards supporting the processor. Input VCCPLL provides isolated power for internal processor FSB PLLs. VCC_SENSE is an isolated low impedance connection to processor Output core power (VCC). It can be used to sense or measure voltage near the silicon with little noise. Output This land is provided as a voltage regulator feedback sense point for VCC. It is connected internally in the processor package to the sense point land U27 as described in the Voltage Regulator Design Guide. 72 Datasheet