JVC GY-HM700UXT 132 page operation manual for the GY-HM700 solid state camcord - Page 76

Menu Display and Detailed Settings Record Set Menu (continued) Clip Set Menu * Default values are indicated in bold characters. Item Clip Name Prefix Reset Clip Number Setting Values xxxG (The default value of xxx is the last 3 digits of the serial number.) ^ Function For setting the first 4 characters of the name of the clip file to be recorded to the SDHC card. Enter any of the 38 characters including alphabets (upper case), numbers (0 to 9), "_" (underscore), and "-" (hyphen) using the software keyboard. (A Page 67 [Text Input with Software Keyboard]) For assigning a new number to (Clip Number) by resetting it (0001). Select [Reset] and press the Set button (R) to reset the number. When other clips exist on the SDHC card, the smallest available number is used after reset. Example: If the [Clip Name Prefix] is AABCDB, and AABCD0001B already exists on the SDHC card, AABCD0002B will be assigned. Audio Set Menu Item Input1 Mic Ref. Setting Values -50dB -60dB Input2 Mic Ref. -50dB -60dB Mic Wind Cut Both Input2 Input1 Off Audio Ref. Level -12dB -20dB Audio Limiter On Off Test Tone On Off Function For setting the reference input level when the [AUDIO INPUT1] button is set to AMICB or AMIC+48VB. -50dB : Sets -50 dB as the reference value. -60dB : Sets -60 dB as the reference value. For setting the reference input level when the [AUDIO INPUT2] button is set to AMICB or AMIC+48VB. -50dB : Sets -50 dB as the reference value. -60dB : Sets -60 dB as the reference value. For selecting whether to cut the low frequencies of the audio input signals (low-cut) when the [AUDIO INPUT 1/2] button is set to AMICB or AMIC+48VB. Set this item to reduce wind noise from the microphone. Both : Enables low-cut on both the [INPUT1] and [INPUT2] terminals. Input2 : Enables low-cut on the audio of the [INPUT2] terminal only. Input1 : Enables low-cut on the audio of the [INPUT1] terminal only. Off : Disables low-cut. For setting the audio reference level to be recorded to the SDHC card. (Applies to both [CH1/CH2].) -20dB : Outputs signals of the reference level when the meter is at -20 dBFS. -12dB : Outputs signals of the reference level when the meter is at -12 dBFS. For specifying whether to trigger the limiter when the [AUDIO SELECT CH-1/CH-2] switch is set to AMANUALB. On : Triggers the limiter when excessive audio signals are input, and compresses the recording level. Off : Does not trigger limiter. For specifying whether to output the audio test signals (1 kHz) during color bar output. On : Audio test signals are output. Off : Audio test signals are not output. 72