Kyocera TASKalfa 181 181/221 Operation Guide Rev-2 - Page 40

Preparation before Use Setting Date and Time Follow the steps below to set the local date and time at the place of installation. When you send an E-mail using the transmission function, the date and time as set here will be printed in the header of the E-mail message. Set the date, time and time difference from GMT of the region where the machine is used. NOTE: Be sure to set the time difference before setting the date and time. System Menu / Counter: Job Accounting Copy Default Machine Default Enter Pin Code using # key. 1 After turning on the main power switch, press the System Menu/Counter key. 2 Press U or V repeatedly until Machine Default appears, and press the Enter key. 3 Use the numeric keys to input the four-digit management code. The management code at the factory default setting is 1800 for the 18 ppm model and 2200 for the 22 ppm model. Machine Default : End Auto Cassette SW Paper Size(1st) : On : Auto I Machine Default : Low Power Time Key Sound On /Off Date/Time : : 1 Min. : On : 06:33 Date /Time: Time DST Time Zone : 06:33 : On : GMT+00:00 Date /Time: End Time DST : 06:33 : On NOTE: The four-digit management code can be changed. For details, refer to Administrator Management Code Change on page 6-24. If the management code is accepted, the Machine default screen is displayed. NOTE: The * (asterisk) at an item on each setting screen indicates the current setting. 4 Press U or V to select Date/Time, and then press the Enter key. 5 Press U or V to select Time Zone and then press Y or Z to set the time difference. 6 Press U or V to select Time and then press Y or Z to set the current time. 2-8 OPERATION GUIDE