LG 40LV570H INSTALLATION - Page 14

EZ-Manager Wizard (Cont.) Zone and Room Number Assignments You may complete one or more of the fields in the Zone, Label, and Room Number screen or leave them at their default settings (Zone) or blank (Label and Room Number), as desired; however, if you intend to use the Zoning feature on this TV, you MUST specify the appropriate value in the Zone field as described below. See also Reference section, "Using the TV Zoning Feature," for further information. Note: The Zoning feature is only applicable for TVs that will be configured using a ".tlx" file (local or remote configuration). Z EZ-Manager Wizard 1 234 Zone, Label, and Room Number • If creating Zones for Installer Menu settings and/or Channel Mapping, select the appropriate Zone # (0-8) based on the Zone in which this TV is installed. (See Commercial Mode Setup Guide for more information.) • Select a Label and/or use the alphanumeric keypad on the remote to input the Room Number. • When done, select 'Next' to continue. Zone Label 0 ----- Room Number 123 456 789 CHAR/ NUM 0 DEL Q.MENU INPUT TV DVD MARK CC VOL TIMER DELETE MUTE P CH A G E PORTAL INFO GUIDE Exit USB Configuration Zone & Room Number Next 1. Complete the appropriate field(s) as described below. Use the Left/Right arrow keys on the Installer Remote to navigate between each of the fields. • Zone: Enables you to set a TV Zone # so that the TV can be configured with Installer Menu and/or Setup Menu settings intended only for the assigned Zone. The Installer Menu and/ or Setup Menu settings may be provided in a Clone/Configuration (.tlx) file. If the TV is being configured for FTG Mode via CPU, the TV Zone # setting also allows the TV to omit channels that have been restricted in the FTG Channel Map. To change the TV Zone from its default value (0), navigate to the Zone field at the left of the screen, and use the Up/Down arrow keys to specify the desired TV Zone # (1-8). • Label: Allows you to select a North, South, East, or West text label for this TV. In the Label field, use the Up/Down arrow keys to select the applicable label. • Room Number: Allows you to specify the number of the room-up to 16 characters-in which the TV is located. In the Room Number field, you can use the number keys on the Installer Remote to direct enter a room number. Use the Dash key on the Installer Remote as necessary to toggle between number and letter characters in the Room Number field. Also, you can use the Flashback key on the Installer Remote to delete characters in this field. 2. When you are ready to continue, select the appropriate option, as follows: • To proceed to the next EZ-Manager screen, use the arrow keys to select Next, and then press OK on the Installer Remote. Continue to the "Configure Pro:Centric Settings" section on the following page. • To use a USB memory device to complete the configuration, select USB Configuration. See "USB Configuration" on pages 18 to 19 for further information 14 206-4317 Draft A.2