LG 40LV570H INSTALLATION - Page 51

Reference: Remote Jack Pack / TV Connections & Setup Remote Jack Pack Setup RJP Available? If you will use a Remote Jack Pack (RJP) in your system, set Installer Menu item 093 RJP AVAILABLE appropriately (for example, on a legacy model RJP: HDMI Mode, set RJP AVAILABLE to 1). See Installer Menu detailed descriptions for further information. 093 RJP AVAILABLE 001 TV Connections Caution: Make these connections ONLY after Master TV Setup and TV cloning procedures are complete. Also, make sure to use the RJ-45 Control cable from the RJP cable bundle to make the connection to the TV's RJP port. Do NOT connect a standard Ethernet cable to the RJP port, as this may damage the TV and network equipment. Refer to the figure below, and connect the RJ-45 Control cable from the RJP cable bundle to the RJP port on the TV's rear jack panel. Then, connect HDMI, RGB, and Composite Video/Audio connectors, as applicable, for the cable bundle. RJP Connect RJ-45 Control cable from RJP cable bundle. RGB IN (PC) Connect RGB connector from RJP cable bundle (legacy RJP only). SPEAKER OUT LINE OUT LAN RJP Use Only OPTICAL DIGITAL AUDIO OUT 1 RGB IN (PC) IN GAME CONTROL / MPI L R TV-LINK CFG RESET UPDATE SERVICE VIDEO L/MONO -AUDIO- R ONLY AV IN/AUDIO IN (RGB DVI) ANTENNA / CABLE IN HDMI IN 1 Connect HDMI connector from RJP cable bundle. AUDIO/VIDEO IN Connect Composite Video/Audio connectors from RJP cable bundle. (Composite Video on legacy RJP only.) 206-4317 Draft A.2 51