LG 40LV570H INSTALLATION - Page 35

Custom Master TV Setup (Cont.) Custom Master TV Setup Procedure 1. Turn ON the TV. The next step depends on whether the EZ-Manager Wizard appears on the screen when you turn ON the TV: • If the wizard is displayed, the TV is in the required factory default state. Exit the wizard, and then continue with step 2. • If the wizard is not displayed, restore the TV to a factory default condition before continuing with this procedure. See Reference section, "Restoring Factory Defaults on the TV(s)," as necessary, for further information. 2. Set Installer Menu items. This step provides specific instruction only on the Installer Menu items that should be set on a Master TV. Refer to pages 23 to 33 for detailed information on all Installer Menu items. a) Use the Installer Remote to access the Installer Menu (see "Accessing the Installer Menu" on page 23 for further information). b) Set Installer Menu item 003 BAND/AFC, as appropriate. • Broadcast: Set to 0. • HRC: Set to 2. • CATV: Set to 1 (default). • IRC: Set to 3. c) Set any other Installer Menu items that affect your TV programming network to the required configuration. For example, enable/disable Aux inputs, set a Start Channel, etc. d) After you have adjusted all Installer Menu item settings as required, and if you do not need to configure any IP Environment settings (see note below), press OK once on the Installer Remote to save your changes; then, press OK again to exit the menu. Note: If you intend to configure settings in the IP Environment Menu, which is accessible from the Installer Menu, you can proceed directly to step 3. All Installer Menu settings will be saved automatically when you access the IP Environment Menu. 3. Configure IP Environment settings. Note: You cannot return directly to the Installer Menu from the IP Environment Menu; thus, you may wish to set all Installer Menu items as needed before you access the IP Environment Menu. Otherwise, you will need to reaccess the Installer Menu to set additional items. Navigate to Installer Menu item 119 DATA CHANNEL, and press 2-5-3 + MENU SETTINGS to launch the IP Environment Menu. Then, complete network configuration as required. See "IP Environment Setup" on pages 47 to 50 for further information. 206-4317 Draft A.2 PTC INSTALLER MENU xxLV570H CPU - CTV 000 INSTALLER SEQ 000 UPN 000-000-000-000 ASIC D279 PTC V#.##.### CPU V#.##.##.## Typical Installer Menu 003 BAND/AFC 001 Adjust the value for this Installer Menu item, as required. (Continued on next page) 35