Olympus E620 E-620 Instruction Manual (English) - Page 81

4 Use the super control panel to set the flash mode and other settings for each group. Flash intensity value Group • Select the flash control mode and adjust the flash 2009. 03.16 RC TTL +1.0 Normal flash/Super FP flash • Switch between normal flash and Super FP flash. intensity individually for groups A, B, and C. For MANUAL, select the flash M 1/8 OFF - LO Communication light level 2 • Set the communication light level to [HI], [MID], or [LO]. intensity. Flash control Flash mode intensity 5 Select a flash mode. Channel • Set the communication channel to the same channel used on the flash. • Red-eye reduction flash is not possible in RC mode. 6 Press the # button to raise the built-in flash. 7 After shooting preparations are completed, take some test shots to check the flash operation and images. 8 Begin shooting while checking the charging completed indications of the camera and flash. 5 x Notes Flash shooting • Although there is no limit to the number of wireless flashes you can use, it is recommended that each group have no more than three flashes to prevent flash malfunction due to mutual interference. • In RC mode, the built-in flash is used to control the wireless flash. The built-in flash cannot be used for flash shooting in this mode. • For 2nd curtain synchronization, set the shutter speed and anti-shock settings to within 4 seconds. Wireless flash shooting may not operate properly when using a slower shutter speed or anti-shock setting. Using commercially available flashes You cannot use the camera to adjust the amount of light emitted from a commercially available flash except for a flash specified for use with this camera. To use a commercially available flash, connect it to the hot shoe. Set the camera's shooting mode to M. Non-specified commercial flashes 1) Exposures when using a flash require that adjustments be made on the flash. If a flash is used in the auto mode, match it with the f-number and ISO sensitivity settings on the camera. 2) Even if the flash auto f-number and ISO sensitivity are set the same as on the camera, the correct exposure may not be obtained depending on the shooting conditions. In such a case, adjust the auto f-number or ISO on the flash or calculate the distance in the manual mode. 3) Use a flash with an illumination angle that matches the focal length of the lens. The focal length of the lens for 35 mm film is approximately twice as long as the focal length of the lenses designed for this camera. 4) Do not use a flash unit or other accessory TTL flash that has additional communication functions other than the specified flashes, since it may not only fail to function normally, but may also cause damage to the camera's circuitry. 81 EN